Effect of oxygen on regulation of properties of moderately boron-doped diamond films

Regulation of oxygen on properties of moderately boron-doped diamond films is fully investigated. Results show that, with adding a small amount of oxygen (oxygen-to-carbon ratio < 5.0%), the crystal quality of diamond is improved, and a suppression effect of residual nitrogen is observed. With increasing ratio of O/C from 2.5% to 20.0%, the hole concentration is firstly increased then reduced. This change of hole concentration is also explained. Moreover, the results of Hall effect measurement with temperatures from 300 K to 825 K show that, with adding a small amount of oxygen, boron and oxygen complex structures (especially B₃O and B₄O) are formed and exhibit as shallow donor in diamond, which results in increase of donor concentration. With further increase of ratio of O/C, the inhibitory behaviors of oxygen on boron leads to decrease of acceptor concentration (the optical emission spectroscopy has shown that it is decreased with ratio of O/C more than 10.0%). This work demonstrates that oxygen-doping induced increasement of the crystalline and surface quality could be restored by the co-doping with oxygen. The technique could achieve boron-doped diamond films with both high quality and acceptable hole concentration, which is applicable to electronic level of usage.     

Experimental and numerical simulation of effects of CO2/N2 concentration and initial temperature on combustion characteristics of biomass syngas

Biomass syngas is a form of renewable energy with very broad application prospects, and it has different combustion characteristics according to the fuel composition and processing technology of biomass syngas. The influence of combustion composition, diluent and temperature variation on combustion characteristics were studied in this paper. The FFCM-1 mechanism was used to investigate the combustion characteristics of CO/CH₄/H₂ under varied diluents CO₂/N₂ and temperature by using spherical expansion flame method and ANSYS CHEMKIN-PRO. The experimental laminar burning velocity was compared with the simulation results of FFCM-1 mechanism. The results reveal that the experimental data are in good agreement with the simulation results, which are somewhat different under the condition of rich fuel. The laminar burning velocity decreases significantly with the increase of diluent CO₂/N₂, with the effect of diluent CO₂ being more significant. The laminar burning velocity increase dramatically with the increase of initial temperature, and the adiabatic flame temperature also decreases with the increase of diluent. The reduction caused by diluent CO₂ is much larger than that caused by diluent N₂. The change of initial temperature also affects the adiabatic flame temperature, but the range of variation is not as pronounced as that of diluent. Not only was the interaction between the combustion characteristics of CO/CH₄/H₂ under different diluents and temperature changes explored in this paper, but the influence mechanism was also revealed in depth.     

蛋白质-多糖复合体系在活性物质传递中的应用

蛋白质-多糖复合体系作为生物活性物质传递系统的壁材,有着人工合成聚合物或无机物等其他材料不可比拟的多重优势。本文就蛋白质和多糖之间的连接方式及蛋白质-多糖复合体系形成传递系统的多种形式进行了综述,以及对此领域的发展趋势进行了展望。结合蛋白质和多糖的结构特点,二者之间的链接方式分为非共价结合的物理共聚,和共价结合的美拉德偶联、化学交联、酶催化交联等方式,文中分别对各种连接方式的原理和机理,以及其影响因素做了深入阐述。以蛋白质-多糖复合体系为壁材对活性物质的传递形式大体上分成乳化系统、胶束、纳米凝胶、分子复合物以及壳核结构等系统。不同的活性物质的特征和传递需求,可针对性地选择合适结构的蛋白质和多糖种类以及二者的连接方式和传递系统的形式。并且,随着研究的逐步发展和推进,此领域的发展趋势朝着智能化和靶向性的方向进行。目前活性物质的蛋白质-多糖复合体系的传递系统,还依然面临着系统设计、评价和应用等多方面的挑战,这就要求我们在更全面更深入了解认识其对活性物质影响和功效的基础上,安全合理地设计和深入细致地评价活性成分的传递系统。     

Pyridine solvated dioxouranium complex with salen ligand: Synthesis,characterization and luminescence properties

A new derivative of dioxouranium(VI) salen complex, [UO2(L)(pyridine)], where [L = N,N′-Bis(2-hydroxybenzylidene)-2,2-dimethyl-1,3-propanediamine] is synthesized and characterized by elemental analysis (C, H, N), FT-IR, ESI-MS spectrometry, UV/Vis, fluorescence, ¹H and ¹³C NMR spectroscopy and thermal gravimetric (TG) study. Furthermore, the single crystal X-ray diffraction measurements of the complex were carried out at 100 and 273 K. The crystal structure measurements revealed that the complex has distorted pentagonal bipyramidal geometry with uranium atom located at the centre and bonded to two phenoxy oxygen and two azomethine nitrogen in tetradenate fashion and one nitrogen from pyridine making it seven coordinated. In addition, the photoluminescence property of the complex was also recorded.     

Synthesis,cytotoxicity, apoptosis and cell cycle arrest of a monoruthenium(II)-substituted Dawson polyoxotungstate

By 5-h reaction of cis-[Ru^IICl₂(DMSO)₄] (M2) with K₁₀[α₂-P₂W₁₇O₆₁] (M3) in ice-cooled, HCl-acidic aqueous solution, a water-soluble 1:2-type diamagnetic ruthenium(II) complex of formula K₁₈[Ru^II(DMSO)₂(P₂W₁₇O₆₁)₂]·35H₂O (M1) was unexpectedly obtained as an analytically pure, homogeneous tan-colored solid, in which two DMSO ligands are coordinated to the ruthenium(II) atom. The cytotoxic potential of the complex was tested on C33A, DLD-1, and HepG-2 cancer cells and human normal embryonic lung fibroblasts cell MRC-5; the viability of the treated cells was evaluated by MTT assay. The mode of cell death was assessed by morphological study of DNA damage and apoptosis assays. Compound M1 induced cell death in a dose-dependent manner, and the mode of cell death was essentially apoptosis though necrosis was also noticed. Cell cycle analysis by flow cytometry indicated that M1 caused cell cycle arrest and accumulated cells in S phase.     

Synthesis and properties of novel N,C,N terdentate skeleton based on 1,3-di(pyridin-2-yl)benzene moiety-new tricks for old dogs

Utilization of intermolecular Friedel-Crafts and intramolecular condensation reaction,novel 1,3-di-(pyridine-2-yl)benzene(N,C,N terdentate) skeleton with electro-withdrawing group in 6' position of pyridyl and a cyclization between 6' position of pyridyl and 6 position of benzyl ring were firstly designed and synthesized.The structures of these novel N,C,N terdentate were confirmed by NMR,MS and X-ray single crystalanalyses.The photophysical properties of these compounds were briefly explored.     

Cyclohexane‐1,3‐dione as a derivatizing agent for the analysis of aldehydes by micelar electrokinetic chromatography with diode array detection

Aldehydes are important compounds in a large number of samples, especially food and beverages. In this work, for the first time, cyclohexane‐1,3‐dione (CHD) was used as a derivatizing reagent aiming aldehyde (formaldehyde, acetaldehyde, propionaldehyde, and valeraldehyde) analysis by MEKC‐DAD. The optimized separation of the derivates was performed using a voltage program (+20 kV, 0–15 min.; +23 kV, 15–17 min.) at a temperature of 26°C, and using as the running buffer a mixture containing 100 mmol/L of sodium dodecyl sulfate and 29 mmol/L of sodium tetraborate at pH 9.2, with maximum absorbance at 260 nm. CHD was compared with two other derivatizing agents: 3‐methyl‐2‐benzothiazolinone hydrazone and phenylhydrazine‐4‐sulfonic acid. The CHD‐aldehyde derivatives were also characterized by LC‐MS. The calibration curves for all aldehydes had r² above 0.999 and LODs ranged from 0.01 to 0.7 mg/L. The optimized methodology was applied in sugar cane brandy (cachaça) samples successfully. CHD showed to be an alternative derivatization reagent due to its stability, aqueous solubility, high selectivity and sensitivity, reduced impurities, and simple preparation steps.     

基于内聚力模型的快速荷载下CFRP-混凝土界面剪切剥离模拟

鉴于纤维增强复合材料(Fiber Reinforced Polymer, FRP)已在混凝土结构加固中普遍应用, 能有效提高结构的承载和变形能力. 为揭示动载作用下FRP-混凝土界面的剥离机理, 本文基于ABAQUS平台, 采用内聚力模型模拟CFRP-混凝土界面层, 实现了快速荷载下CFRP-混凝土界面剥离的高效模拟. 结果表明: CFRP表面应变在加载过程中由加载端向自由端方向传递, 随着加载速率的提高, 界面承载能力也随之提高; 界面峰值剪应力也存在显著的应变率效应; 模拟结果与试验结果基本吻合, 说明了新方法的有效性.     

梁柱简化模型在自立塔塔线体系动态响应中的适用性研究

对输电塔进行合理简化可以提高塔线体系动力学仿真的效率。本文给出自立塔梁柱简化模型的计算方法，并提出利用梁柱简化模型计算方法建立自立塔塔线体系整体模型，同时采用桁梁混合模型建立精细化塔线体系整体模型，对两种模型塔线体系静力特性及振型和固有频率等动力特性进行对比分析。以脱冰工况为例，采用生死单元技术将施加在输电线节点上的集中质量单元杀死来模拟脱冰，实现对塔线体系动力学响应的有限元模拟，研究塔线体系简化模型在动态响应中的适用性。结果表明，两种模型弯曲变形误差小，低阶的振型相同，固有频率值误差小，动力特性基本相同；脱冰工况下，自立塔节点位移和塔材内力时程曲线一致，在提高计算效率的情况下，能有效保证计算精度。     

Study on the Interaction and Properties of Cucurbit[8]uril with Oroxin B

The interaction between cucurbit[8]uril(Q[8]) and oroxin B(ORB) was investigated by UV-visible(UV-Vis) spectroscopy, isothermal titration calorimetry(ITC), mass spectrum(MS) and nuclear magnetic resonance(NMR) spectroscopy. The results showed that ORB formed a 2:1 inclusion complex with Q[8] with a binding constant of 8.266×10⁵ L²·mol^-2. ORB had good scavenging ability for 2,2'-azinobis-(3-ethylbenzthiazoline-6-sulphonate)(ABTS) free radicals(IC₅₀=5.74 μmol/L) and the addition of Q[8] did not significantly affect the antioxidant activity of ORB(IC₅₀=5.76 μmol/L). A phase solubility experiment revealed a 1.86-fold increase in the solubility of ORB when c(Q[8])=100 μmol/L. In vitro drug release experiments showed that the release rate for ORB@Q[8] complex was lower than that of ORB in artificial intestinal juice, and higher than that of ORB in artificial gastric juice.